Always having mass balance issues when utilising flow through structure. It could be something from adding orifice to inlets same size as pipe, lifting/dropping structure slightly increasing/decreasing length of structure, that sorts the issue. Th...
In the new update when you add the porosity it displays that porosity but it is quite an eye sore and would be beneficial to be able to remove or tone it down a bit.
Improved modelling, including building drainage so designs can be modelled to base of internal stacks within buildings to allow for greater collaboration between other design disciplines for general clash detection. Typically, Architects, Structur...
Drive - When creating vehicles enable wheels on separate axles to be adjusted
At present you cannot have varying wheel sizes on each axle and instead can only have one fixed wheel size and width. This therefore means we cannot have accurate swept paths tracks for for vehicles and/or trailers where the wheels sizes change. A...
To be able to show pipe crossings when plotting long sections.
When plotting long sections, it would be useful to be able to show the crossings from other drainage networks. The crossing are shown on the long sections viewer in flow but not when you plot them.
I have a request regards time to half empty of infiltration systems. Irrespective of what I set in the preference page (whether time to half empty by volume or by storm) I just get time to half empty of the structure. That isn’t very useful inform...
Steve Doughty
11 months ago
in Flow
0
👷🏽♀️Promoted
The sum of the total impermeable area is not currently printed on the calcs, this could be incorporated with the total Time/Area information (as per a previous suggestion) as MicroDrainage does.
Ian George
about 2 years ago
in Flow
0
👷🏽♀️Promoted
The mimimum pipe length in Flow is currently set to 1m. Where modelling junctions and connections there may be less than 1m between the junctions. Please revise the minimum length to around 300-500mm.
Ian George
about 2 years ago
in Flow
1
👷🏽♀️Promoted
0
📋Registered
0
