some sites we are working on have had some significant level differences, which has led to the need for retaining walls. At present Live Design tries to grade the surface between these level differences. Please can you add a feature where a retain...
The Envelope Outline is good but for some reason a vehicle outline is drawn at each of the Intermediate Points, which looks messy, and if Intermediate Points are displayed then that also looks messy with lots of overlapping vehicle outlines. It wo...
The ability to create a regular grid of surface cross sections at set intervals will be very useful - similar to the Sections command available within PDS. This would need to identify the cross section positions on the layout plan and identify the...
Ian Woolgar
over 2 years ago
in LiveDesign
0
Planned
Vertical Design – Design setting option where we can specify that the levels should be a certain height above or below existing ground levels
Is it feasible to look into an option whereby we can specify the height above or below existing ground that the designs should be set? This should allow designers to easily adjust levels to help achieve a cut and fill balance
Mick Taylor
about 1 year ago
in LiveDesign
2
Already exists
It would be useful to be able to add a description to manhole labels to provide descriptions such as 'existing manhole to be retained', 'recessed cover', etc.
It would be really useful to be able to align rectangular manholes to match the architectural constraints of a building such as a orientation of a corridor/wall. Currently LiveDesign can only show manholes with the orientation centred and perpendi...
Drive - When creating vehicles enable wheels on separate axles to be adjusted
At present you cannot have varying wheel sizes on each axle and instead can only have one fixed wheel size and width. This therefore means we cannot have accurate swept paths tracks for for vehicles and/or trailers where the wheels sizes change. A...
Given that there are other CAD based Packages other than those by AutoDesk, it would be useful to be able to run Live Design within others, probably one of the largest alternatives is BricsCAD - pair this with greater functionality within the Swep...
2
Already exists
0
