All ideas

Can rear steering be enabled to be applied to the trailer units of articulated vehicle. The new max. legal length articulated vehicle trailers encompass rear streering.

In the new update when you add the porosity it displays that porosity but it is quite an eye sore and would be beneficial to be able to remove or tone it down a bit.

user defined section entry is confusing and misleading. "Width" implies overall width of section whereas we are actually required to add coordinates for each side of the section. Relabel the columns, and/or maybe include help link to an example.

Can a function be added to allow users to model building connections such as foul connections or connections from RWPs. This would allow the modelling of all below ground drainage in one model and allow BIM collaboration with other design discipli...

It will be beneficial if the outflow rates below 1 litres per second can be specified to the exact decimal point. This is because a minimal change in a small outflow can have an impact on the storage required.

There is an absence of guidance on the use of ReFH2 data in Flow. I understand from discussions with the Help Desk that they don't have access to the software. In the absence of reasonable guidance the ReFH2 features are worthless.

Add chainage, pipe bedding and node cover grade information as options for long section outputs. These are standard requirements for a lot of water authorities so would prevent manual changes being required to allow these outputs to be included.

Specifically for exporting the results of flood flow analysis. Currently a dxf can be created, but when opened in BricsCAD it comprises a proxy entity block with no colour to the squares for depth and velocity. It would be useful to have a dxf wit...

We’ve noticed a significant increase in the use of precast manholes across nearly every development we’re involved in. The companies supplying these typically issue drawings where each incoming pipe is referenced by its angle relative to the outgo...

Looking for the ability to use the system to calculate the 200yr pre development greenfield discharge for a development site. Currently you can only calculate the 1,2,5,10,25,30,50,100,500