All ideas

It will be beneficial if the outflow rates below 1 litres per second can be specified to the exact decimal point. This is because a minimal change in a small outflow can have an impact on the storage required.

Looking for the ability to use the system to calculate the 200yr pre development greenfield discharge for a development site. Currently you can only calculate the 1,2,5,10,25,30,50,100,500

The gradients are shown on pipes are currently shown to 1 decimal place. E.G 1:300.0 which is unnecessary, it should be 1:300 or at least be able to change the previsions.

Having the ability to reorder the columns and save as a user preference to avoid scrolling across the 30+ columns without having to hide them individually.

Given the development of "fit to outlet pipes (XP)" and the ability to manually set the Flush-Flow point on other ones, it would be useful to be able to have more flexibility within flow to either manually select a specific hydrobrake or at least ...

It currently isn't possible for a user to find out who is holding the licences in the CLM. This is useful because it allows users to ask the users directly if they are still using the licence without needing to get the organisational admin to find...

It currently isn't possible for a user to find out who is holding the licences in the CLM. This is useful because it allows users to ask the users directly if they are still using the licence without needing to get the organisational admin to find...

Water authorities are asking for a foul water network analysis to confirm the velocities, pipe diameters and flows. Flow cannot provide this information because the foul network has not outlet and it gets flooded. Your response is to add an hydrog...

Ability to define design parameters used in network design, a bit more granularity than enforce best practice yes/no.

Ability to indicate manholes where the designer will allow a user specifiable backdrop would be useful.