Design Ideas Portal
ADD A NEW IDEA

All ideas

Showing 143 of 143

When are we getting the ability to model complex junctions?

We have a second Phase to progress of a project previously modelled in PDS, which incorporated complex road junctions. This cannot be imported correctly into live design and is therefore causing an issue.
Ian Woolgar over 2 years ago in LiveDesign 0 Planned

Incorporate overland flow analysis with below ground drainage design

Provide ability to either have overland flow draining into a pipe network or flooding out of a pipe network to be able to model resulting overland flow paths / flood extents
Ian Woolgar over 2 years ago in LiveDesign 0 Already exists

When modelling overland flows, need the ability to easily add swales / channels to the finished surface

Using the 'Modify levels' command to create a swale feature works, however, this does not create an entity that can be either revised or deleted.
Ian Woolgar over 2 years ago in LiveDesign 0

Ability to set individual plot boundary levels and use these to adjust the finished surface (boundary to be any polygon shape)

Increasingly we are working on steep sites where we need to try and make usable gardens by setting gradients, often resulting in level changes at boundaries requiring retaining walls
Ian Woolgar over 2 years ago in LiveDesign 0

Outflow rates below 1 l/s to be specified to exact decimal point

It will be beneficial if the outflow rates below 1 litres per second can be specified to the exact decimal point. This is because a minimal change in a small outflow can have an impact on the storage required.
Guest over 1 year ago in Flow 0 👷🏽‍♀️Promoted

Ability to reorder columns to user preference

Having the ability to reorder the columns and save as a user preference to avoid scrolling across the 30+ columns without having to hide them individually.
Ryan James 11 months ago in Flow 0 👷🏽‍♀️Promoted

200yr Pre Greenfield Runoff

Looking for the ability to use the system to calculate the 200yr pre development greenfield discharge for a development site. Currently you can only calculate the 1,2,5,10,25,30,50,100,500
Guest almost 2 years ago in Flow 0 👷🏽‍♀️Promoted

The gradients are shown on pipes are currently shown to 1 decimal place. E.G 1:300.0 which is unnecessary, it should be 1:300 or at least be able to change the previsions.

The gradients are shown on pipes are currently shown to 1 decimal place. E.G 1:300.0 which is unnecessary, it should be 1:300 or at least be able to change the previsions.
Guest almost 2 years ago in LiveDesign 0 Planned

select hydrobrakes manually and/or change the flush-flow point

Given the development of "fit to outlet pipes (XP)" and the ability to manually set the Flush-Flow point on other ones, it would be useful to be able to have more flexibility within flow to either manually select a specific hydrobrake or at least ...
Guest 11 months ago in Flow 0 👷🏽‍♀️Promoted

Foul network analysis

Water authorities are asking for a foul water network analysis to confirm the velocities, pipe diameters and flows. Flow cannot provide this information because the foul network has not outlet and it gets flooded. Your response is to add an hydrog...
Guest 12 months ago in Flow 0 👷🏽‍♀️Promoted