Looking for the ability to use the system to calculate the 200yr pre development greenfield discharge for a development site. Currently you can only calculate the 1,2,5,10,25,30,50,100,500
Drawing outputs such as long sections and manhole schedules to indicate manhole & pipe reference prefixes and suffixes the same way as it appears on the plan
For example if I set "F" prefix for the foul chambers in "Annotations", the manholes on the layout will appear as intended (F1, F2, etc...). However these prefixes are ignored when generating other drawing outputs such as schedules or long section...
It would be helpful to have following parameters, including the ability to define them globally as well as locally (for node or links) Maximum gradient Minimum Gradient Maximum drop Allow Drop (locally) Maximum cover
Specify check points in a model where discharges rates and peak flow results can be generated, the results should have the ability to be added to the design report. Could this include a graph of the flows at this check point too?
Tom Fox
almost 2 years ago
in Flow
0
👷🏽♀️Promoted
0
👷🏽♀️Promoted
