Skip to Main Content
Design Ideas Portal
Product LiveDesign
Created by Guest
Created on Jul 14, 2023

Merge wheel of vehicle tracking

Providing an option to “merge” the front/rear wheels so there is a single maximum extent of wheel line is shown on each side rather than a pair of lines (again sometimes simplifying this makes it easier to explain to others and makes drawings at smaller scales easier to read with a reduced number of lines), would make the presentation of the paths much better, especially when reviewing on drawings of scales of 1:500 or 1:1,000 where too many lines result in a far too complex picture when trying to see what is going on.


As whilst there is an option to show just the body overhang, there are times when this can over sail a verge, but the wheels can not.

  • Attach files